Ready for Fall Nitrogen Application? Think Again!
November 5th, 2026
As harvest starts to wrap up, thoughts turn in some areas to fall application of nitrogen for next year's corn crop. While not a universal practice, fall nitrogen application is common enough across the Midwestern US that it is worthy of discussion here. And while this practice may seem like a "set and forget" situation, it actually warrants a fair amount of management.
Many farmers choose to apply nitrogen in the fall after harvest to reduce workload in the spring. Having nitrogen applied where it can be held over the winter allows a farmer to get a jump on spring tillage and planting. It's not something that can or should be done everywhere, but even where conditions may allow it, there are a few things to consider.
In this article I'll outline some key points about fall nitrogen application that should be considered.
9 Points About Fall Nitrogen
Lighter soils (sands, loamy sands, sandy loams and even some loams) and fall nitrogen applications don't go together. There is not enough holding capacity to keep nitrogen in the soil profile until it is needed for the following early summer. Please do not attempt fall nitrogen application on these lighter soil types.
Anhydrous ammonia is the primary source of nitrogen applied in the fall, but urea may be applied as well, often where ammonia was previously available but has left the area. In more northern areas (Minnesota, South and North Dakota) urea is a common nitrogen source. However, ammonia is the main source for the rest of the Corn Belt.
If one is using urea, it is best to be banded below the surface, and if that is not possible, incorporation is the next best (but not great) solution. Leaving any urea prills on the surface for an extended period can allow for volatilization, or loss of nitrogen as ammonia gas. Banding through strip-till greatly reduced volatilization loss from urea.
Wait, please wait until the soil temperature at a 4-inch depth is at 50F or less and falling. Nitrification, the conversion of ammonium to nitrate, is still active while soil temperatures are in the 50's, and only slows to a crawl as it gets closer to freezing. Nitrate-nitrogen is nitrogen at risk of loss, either due to denitrification in wet, warm conditions (usually next spring) or to leaching (anytime). Waiting for proper temperature conditions is sometimes hard to do when you have a lot of work to do in a short time, but both the environment and your pocketbook will thank you for waiting. Sources like the Iowa Environmental Mesonet provide real time and forecasted soil temperature estimates to help plan application timing.
Do not use urea-ammonium nitrate (UAN) as your nitrogen source in the fall. 25% of it is already in the nitrate form and immediately subject to loss. Regardless of the application method, UAN is not advised for fall application.
Always use a nitrification inhibitor with anhydrous ammonia or urea. Products like N-Serve or Centuro A-Pro for ammonia, or Instinct or Centuro U-Pro for urea, are proven to keep ammonium nitrogen in that form longer than without. Even if you've applied your nitrogen sources below 50 F, there is still at risk the temperature may rise above it. Without protection, nitrification can take place and loss occurs.
Don't put all your eggs in one basket – there's still a long way from fall to June next year and attempting to supply all your corn nitrogen needs in one shot 8 months out is not an agronomic sound approach. It often means more nitrogen needs to be applied to achieve top yields. Instead, apply approximately half to two-thirds of your intended nitrogen in the fall, then plan for an early-season application to top off the balance needed, guided by nitrogen management tools like Sentinel's All-N.
Nitrogen soil samples in the late spring (around Memorial Day) are a good way to gauge how much nitrogen is still in the soil, but they require proper sampling techniques, and they may not provide a complete picture without many samples. A few are useful for getting an estimate, especially for capturing a ratio of ammonium to nitrate. Nitrogen soil samples may be of more value in drier regions than more watered areas.
Many of these management practices hold true for liquid manure as well. While manure is applied at greater volume due to lower nutrient concentrations, ammonium nitrogen is still present, and the same rules about soil temperature, nitrification inhibitors, soil types and placement methods hold true.
These points are made to help us all be better stewards of both the land and our financial resources. While efforts like nitrification inhibitors do cost extra, they end up protecting your investment in the long run. Many fingers are already pointed at agriculture, so doing what is right through proper fall nitrogen management will allow farmers the freedom to operate while still doing what is right for the environment.


%20(1).png)



Comments